Sec. 15.25  Kits.

    A TV interface device, including a cable system terminal device, 
which is marketed as a kit shall comply with the following requirements:
    (a) All parts necessary for the assembled device to comply with the 
technical requirements of this part must be supplied with the kit. No 
mechanism for adjustment that can cause operation in violation of the 
requirements of this part shall be made accessible to the builder.
    (b) At least two units of the kit shall be assembled in exact 
accordance with the instructions supplied with the product to be 
marketed. If all components required to fully complete the kit (other 
than those specified in paragraph (a) of this section which are needed 
for compliance with the technical provisions and must be included with 
the kit) are not normally furnished with the kit, assembly shall be made 
using the recommended components. The assembled units shall be certified 
or notified, as appropriate, pursuant to the requirements of this part.
    (1) The measurement data required for a TV interface device subject 
to certification shall be obtained for each of the two units and 
submitted with an application for certification pursuant to subpart J of 
part 2 of this chapter.
    (2) The measurement data required for a TV interface device subject 
to notification shall be obtained for the units tested and retained on 
file pursuant to the provisions of subpart J of part 2 of this chapter.
    (c) A copy of the exact instructions that will be provided for 
assembly of the device shall be submitted with an application for 
certification or notification. Those parts which are not normally 
furnished shall be detailed in the application for equipment 
authorization.
    (d) In lieu of the label required by Sec. 15.19, the following 
label, along with the label bearing the FCC identifier and other 
information specified in Secs. 2.925 and 2.926, shall be included in the 
kit with instructions to the builder

[[Page 619]]

that it shall be attached to the completed kit:

                            (Name of Grantee)

                            (FCC Identifier)

    This device can be expected to comply with part 15 of the FCC Rules 
provided it is assembled in exact accordance with the instructions 
provided with this kit. Operation is subject to the following 
conditions: (1) This device may not cause harmful interference, and (2) 
this device must accept any interference received including interference 
that may cause undesired operation.

    (e) For the purpose of this section, circuit boards used as repair 
parts for the replacement of electrically identical defective circuit 
boards are not considered to be kits.