FCC 80.211 Revised as of October 1, 2005
Goto Year:2004 |
2006
Sec. 80.211 Emission limitations.
The emissions must be attenuated according to the following schedule.
(a) The mean power when using emissions H3E, J3E and R3E:
(1) On any frequency removed from the assigned frequency by more than 50
percent up to and including 150 percent of the authorized bandwidth:
at least 25 dB for transmitters installed before February 1, 1992,
at least 28 dB for transmitters installed on or after February 1, 1992;
(2) On any frequency removed from the assigned frequency by more than 150
percent up to and including 250 percent of the authorized bandwidth: At
least 35 dB; and
(3) On any frequency removed from the assigned frequency by more than 250
percent of the authorized bandwidth: At least 43 plus 10log[10] (mean power
in watts) dB.
(b) For transmitters operating in the band 1626.5–1646.5 MHz. In any 4 kHz
band the mean power of emissions shall be attenuated below the mean output
power of the transmitter as follows:
(1) Where the center frequency is removed from the assigned frequency by
more than 50 percent up to and including 100 percent of the authorized
bandwidth: At least 25 dB;
(2) Where the center frequency is removed from the assigned frequency by
more than 100 percent up to 250 percent of the authorized bandwidth: At
least 35 dB; and
(3) On any frequency removed from the assigned frequency by more than 250
percent of the authorized bandwidth: At least 43 plus 10log[10] (mean power
in watts) dB.
(c) In any 4 kHz band the peak power of spurious emissions and noise at the
input to the transmit antenna must be attenuated below the peak output power
of the station as follows:
(1) 125 dB at 1525.0 MHz, increasing linearly to 90 dB at 1612.5 MHz;
(2) 90 dB at 1612.5 MHz increasing linearly to 60 dB at 1624.0 MHz;
(3) 90 dB from 1624.0 MHz to 1650.0 MHz, except at frequencies near the
transmitted carrier where the requirements of paragraphs (b)(1) through (3)
of this section, apply;
(4) 60 dB at 1650.0 MHz decreasing linearly to 90 dB at 1662.5 MHz;
(5) 90 dB at 1662.5 MHz decreasing linearly to 125 dB at 1752.5 MHz; and
(6) 125 dB outside above range, except for harmonics which must comply with
(b)(3) of this section.
(d) The mean power of emissions from radiotelephone survival craft
transmitters, 9 GHz search and rescue transponders, and radiotelegraph
survival craft transmitters must be attenuated below the mean output power
of the transmitter as follows:
(1) On any frequency removed from the assigned frequency by more than 50
percent, up to and including 100 percent of the authorized bandwidth: at
least 25 dB;
(2) On any frequency removed from the assigned frequency by more than 100
percent of the authorized bandwidth: at least 30 dB.
(e) The mean power of EPIRBs operating on 121.500 MHz, 243.000 MHz and
406.025 MHz must be as follows:
(1) On any frequency removed from the assigned frequency by more than 50
percent, up to and including 100 percent of the authorized bandwidth: At
least 25 dB;
(2) On any frequency removed from the assigned frequency by more than 100
percent: at least 30 dB.
(f) The mean power when using emissions other than those in paragraphs (a),
(b), (c) and (d) of this section:
(1) On any frequency removed from the assigned frequency by more than 50
percent up to and including 100 percent of the authorized bandwidth: At
least 25 dB;
(2) On any frequency removed from the assigned frequency by more than 100
percent up to and including 250 percent of the authorized bandwidth: At
least 35 dB; and
(3) On any frequency removed from the assigned frequency by more than 250
percent of the authorized bandwidth: At least 43 plus 10log[10] (mean power
in watts) dB.
(g) Developmental stations must conform to the standards for regular
authorized stations.
[ 51 FR 31213 , Sept. 2, 1986, as amended at 54 FR 40058 , Sept. 29, 1989; 54 FR 49994 , Dec. 4, 1989; 56 FR 11516 , Mar. 19, 1991; 62 FR 40306 , July 28,
1997]
CiteFind - See documents on FCC website that
cite this rule
Want to support this service?
Thanks!
Report errors in
this rule. Since these rules are converted to HTML by machine, it's possible errors have been made. Please
help us improve these rules by clicking the Report FCC Rule Errors link to report an error.