Goto Section: 80.911 | 80.915 | Table of Contents

FCC 80.913
Revised as of October 1, 2005
Goto Year:2004 | 2006
Sec.  80.913   Radiotelephone receivers.

   (a) If a medium frequency radiotelephone installation is provided, the watch
   receiver must be capable of effective reception of J3E emissions, be
   connected to the antenna system specified by  Sec. 80.923, and be preset to, and
   capable of accurate and convenient selection of, the frequencies 2182 kHz,
   2638 kHz, and the receiving frequency(s) of public coast stations serving
   the area in which the vessel is navigated.

   (b) If a single sideband radiotelephone installation is provided, the
   receiver must be capable of reception of H3E and J3E emissions on 2182 kHz
   and J3E emission on any receiving frequency authorized pursuant to  Sec. 80.909
   of this part.

   (c) If a very high frequency radiotelephone installation is provided, the
   receiver used for maintaining the watch required by  Sec. 80.303 must be capable
   of effective reception of G3E emission, be connected to the antenna system
   specified by  Sec. 80.923 and be preset to, and capable of selection of, the
   frequencies 156.300 MHz, 156.800 MHz, and the receiving frequency(s) of
   public coast stations serving the area in which the vessel is navigated.

   (d) One or more loudspeakers must be provided to permit reception on 2182
   kHz or 156.800 MHz at the principal operating position and at any other
   place where listening is performed.

   (e) Any receiver provided as a part of the radiotelephone installation must
   have a sensitivity of at least 50 microvolts in the case of MF equipment,
   and 1 microvolt in the case of HF or VHF equipment.

   (f) The receiver required in paragraphs (a), (b) or (c) of this section must
   be capable of efficient operation when energized by the main source of
   energy. When a reserve source of energy is required pursuant to  Sec. 80.905 or
    Sec. 80.917 of this part, the receiver must also be capable of efficient
   operation when energized by the reserve source of energy.

   (g) The sensitivity of a receiver is the strength in microvolts of a signal,
   modulated 30 percent at 400 Hertz, required at the receiver input to produce
   an audio output of 50 milliwatts to the loudspeaker with a signal-to-noise
   ratio of at least 6 decibels. Evidence of a manufacturer's rating or a
   demonstration of the sensitivity of a required receiver computed on this
   basis must be furnished upon request of the Commission.

   [ 51 FR 31213 , Sept. 2, 1986, as amended at  56 FR 19302 , Apr. 26, 1991]


Goto Section: 80.911 | 80.915

Goto Year: 2004 | 2006
CiteFind - See documents on FCC website that cite this rule

Want to support this service?
Thanks!

Report errors in this rule. Since these rules are converted to HTML by machine, it's possible errors have been made. Please help us improve these rules by clicking the Report FCC Rule Errors link to report an error.
hallikainen.com
Helping make public information public