Sec.  95.607   CB transmitter modification.

   Only the holder of the grant of authorization of the particular certificated
   CB transmitter may make the modifications permitted under the provisions for
   certification (see part 2 of this chapter.) No grantee shall make any of the
   following modifications to the transmitter without prior written permission
   from the FCC (Federal Communications Commission):

   (a) The addition of any accessory or device not specified in the application
   for certification and authorized by the FCC in granting the certification;

   (b) The addition of any switch, control or external connection;

   (c) Any modification to provide for additional transmitting frequencies,
   increased modulation level, a different form of modulation, or increased TP
   (RF transmitter power expressed in W (watts), either mean power (TP averaged
   over at least 30 cycles of the lowest modulating frequency, typically 0.1
   seconds at maximum power) or peak envelope power (TP averaged during 1 RF
   cycle at the highest crest of the modulation envelope), as measured at the
   transmitter output antenna terminals.)

   [ 53 FR 36789 , Sept. 22, 1988, as amended at  63 FR 36610 , July 7, 1998]

Technical Standards