Goto Section: 80.911 | 80.915 | Table of Contents

FCC 80.913
Revised as of October 1, 2009
Goto Year:2008 | 2010
  §  80.913   Radiotelephone receivers.

   (a) If a medium frequency radiotelephone installation is provided, the
   receiver must be capable of effective reception of J3E emissions, be
   connected to the antenna system specified by § 80.923, and be preset to,
   and capable of accurate and convenient selection of, the frequencies
   2182 kHz, 2638 kHz, and the receiving frequency(s) of public coast
   stations serving the area in which the vessel is navigated.

   (b) If a single sideband radiotelephone installation is provided, the
   receiver must be capable of reception of H3E and J3E emissions on 2182
   kHz and J3E emission on any receiving frequency authorized pursuant to
   § 80.909 of this part.

   (c) If a very high frequency radiotelephone installation is provided,
   the receiver used for maintaining the watch required by § 80.303 must be
   capable of effective reception of G3E emission, be connected to the
   antenna system specified by § 80.923 and be preset to, and capable of
   selection of, the frequencies 156.300 MHz, 156.800 MHz, and the
   receiving frequency(s) of public coast stations serving the area in
   which the vessel is navigated.

   (d) One or more loudspeakers must be provided to permit reception on
   2182 kHz or 156.800 MHz at the principal operating position and at any
   other place where listening is performed.

   (e) Any receiver provided as a part of the radiotelephone installation
   must have a sensitivity of at least 50 microvolts in the case of MF
   equipment, and 1 microvolt in the case of HF or VHF equipment.

   (f) The receiver required in paragraphs (a), (b) or (c) of this section
   must be capable of efficient operation when energized by the main
   source of energy. When a reserve source of energy is required pursuant
   to § 80.905 or § 80.917 of this part, the receiver must also be capable
   of efficient operation when energized by the reserve source of energy.

   (g) The sensitivity of a receiver is the strength in microvolts of a
   signal, modulated 30 percent at 400 Hertz, required at the receiver
   input to produce an audio output of 50 milliwatts to the loudspeaker
   with a signal-to-noise ratio of at least 6 decibels. Evidence of a
   manufacturer's rating or a demonstration of the sensitivity of a
   required receiver computed on this basis must be furnished upon request
   of the Commission.

   [ 51 FR 31213 , Sept. 2, 1986, as amended at  56 FR 19302 , Apr. 26, 1991;
    73 FR 4487 , Jan. 25, 2008]


Goto Section: 80.911 | 80.915

Goto Year: 2008 | 2010
CiteFind - See documents on FCC website that cite this rule

Want to support this service?
Thanks!

Report errors in this rule. Since these rules are converted to HTML by machine, it's possible errors have been made. Please help us improve these rules by clicking the Report FCC Rule Errors link to report an error.
hallikainen.com
Helping make public information public