Goto Section: 2.803 | 2.807 | Table of Contents

FCC 2.805
Revised as of October 1, 2016
Goto Year:2015 | 2017
  § 2.805   Operation of radio frequency devices prior to equipment
authorization.

   (a) General rule. A radio frequency device may not be operated prior to
   equipment authorization unless the conditions set forth in paragraphs
   (b), (c), (d) or (e), of this section are meet. Radio frequency devices
   operated under these provisions may not be marketed (as defined in
   § 2.803(a)) except as provided elsewhere in this chapter. In addition,
   the provisions of subpart K continue to apply to imported radio
   frequency devices.

   (b) Operation of a radio frequency device prior to equipment
   authorization is permitted under the authority of an experimental radio
   service authorization issued under part 5 of this chapter.

   (c) Operation of a radio frequency device prior to equipment
   authorization is permitted for experimentation or compliance testing of
   a device that is fully contained within an anechoic chamber or a
   Faraday cage.

   (d) For devices designed to operate solely under parts 15, 18, or 95 of
   this chapter without a station license, operation of a radio frequency
   device prior to equipment authorization is permitted under the
   following conditions, so long as devices are either rendered inoperable
   or retrieved at the conclusion of such operation:

   (1) The radio frequency device shall be operated in compliance with
   existing Commission rules, waivers of such rules that are in effect at
   the time of operation, or rules that have been adopted by the
   Commission but that have not yet become effective; and

   (2) The radio frequency device shall be operated for at least one of
   these purposes:

   (i) Demonstrations at a trade show or an exhibition, provided a notice
   containing the wording specified in § 2.803(c)(2)(iii) is displayed in a
   conspicuous location on, or immediately adjacent to, the device; or all
   prospective buyers at the trade show or exhibition are advised in
   writing that the equipment is subject to the FCC rules and that the
   equipment will comply with the appropriate rules before delivery to the
   buyer or to centers of distribution; or

   (ii) Evaluation of performance and determination of customer
   acceptability, during developmental, design, or pre-production states.
   If the device is not operated at the manufacturer's facilities, it must
   be labeled with the wording specified in § 2.803(c)(2)(iii), and in the
   case of an evaluation kit, the wording specified in
   § 2.803(c)(2)(iv)(C).

   (e) Operation of a radio frequency device prior to equipment
   authorization is permitted under either paragraph (e)(1) or (e)(2) of
   this section so long as devices are either rendered inoperable or
   retrieved at the conclusion of such operation:

   (1) The radio frequency device shall be operated in compliance with
   existing Commission rules, waivers of such rules that are in effect at
   the time of operation, or rules that have been adopted by the
   Commission but that have not yet become effective; and

   (i) Under the authority of a service license (only in the bands for
   which that service licensee holds a license) provided that the licensee
   grants permission and the licensee continues to remain responsible for
   complying with all of the operating conditions and requirements
   associated with its license; or

   (ii) Under a grant of special temporary authorization.

   (2) The radio frequency device shall be operated at or below the
   maximum level specified in the table in § 15.209(a) of this chapter for
   at least one of these purposes:

   (i) Demonstrations at a trade show or an exhibition, provided a notice
   containing the wording specified in § 2.803(c)(2)(iii) is displayed in a
   conspicuous location on, or immediately adjacent to, the device; or all
   prospective buyers at the trade show or exhibition are advised in
   writing that the equipment is subject to the FCC rules and that the
   equipment will comply with the appropriate rules before delivery to the
   buyer or to centers of distribution; or

   (ii) Evaluation of performance and determination of customer
   acceptability, during developmental, design, or pre-production states.
   If the device is not operated at the manufacturer's facilities, it must
   be labeled with the wording specified in § 2.803(c)(2)(iii), and in the
   case of an evaluation kit, the wording specified in
   § 2.803(c)(2)(iv)(C).

   [ 78 FR 25162 , Apr. 29, 2013, as amended at  79 FR 48691 , Aug. 18, 2014]

   return arrow Back to Top


Goto Section: 2.803 | 2.807

Goto Year: 2015 | 2017
CiteFind - See documents on FCC website that cite this rule

Want to support this service?
Thanks!

Report errors in this rule. Since these rules are converted to HTML by machine, it's possible errors have been made. Please help us improve these rules by clicking the Report FCC Rule Errors link to report an error.
hallikainen.com
Helping make public information public