Goto Section: 90.671 | 90.673 | Table of Contents

FCC 90.672
Revised as of October 5, 2017
Goto Year:2016 | 2018
  § 90.672   Unacceptable interference to non-cellular 800 MHz licensees from
800 MHz cellular systems or part 22 Cellular Radiotelephone systems, and
within the 900 MHz Business/Industrial Land Transportation Pool.

   (a) Definition. Except as provided in 47 CFR 90.617(k), unacceptable
   interference to non-cellular licensees in the 800 MHz band from 800 MHz
   cellular systems or part 22 of this chapter, Cellular Radiotelephone
   systems and within the 900 MHz Business/Industrial Land Transportation
   (B/ILT) Pool will be deemed to occur when the below conditions are met:

   (1) A transceiver at a site at which interference is encountered:

   (i) Is in good repair and operating condition, and is receiving:

   (A) A median desired signal strength of −104 dBm or higher if operating
   in the 800 MHz band, or a median desired signal strength of −88 dBm if
   operating in the 900 MHz B/ILT Pool, as measured at the R.F. input of
   the receiver of a mobile unit; or

   (B) A median desired signal strength of −101 dBm or higher if operating
   in the 800 MHz band, or a median desired signal strength of −85 dBm if
   operating in the 900 MHz B/ILT Pool, as measured at the R.F. input of
   the receiver of a portable i.e., hand-held unit; and either

   (ii) Is a voice transceiver:

   (A) With manufacturer published performance specifications for the
   receiver section of the transceiver equal to, or exceeding, the minimum
   standards set out in paragraph (b) of this section, and;

   (B) Receiving an undesired signal or signals which cause the measured
   Carrier to Noise plus Interference (C/(I + N)) ratio of the receiver
   section of said transceiver to be less than 20 dB if operating in the
   800 MHz band, or less than 17 dB if operating in the 900 MHz B/ILT
   Pool, or;

   (iii) Is a non-voice transceiver receiving an undesired signal or
   signals which cause the measured bit error rate (BER) (or some
   comparable specification) of the receiver section of said transceiver
   to be more than the value reasonably designated by the manufacturer.

   (2) Provided, however, that if the receiver section of the mobile or
   portable voice transceiver does not conform to the standards set out in
   paragraph (b) of this section, then that transceiver shall be deemed
   subject to unacceptable interference only at sites where the median
   desired signal satisfies the applicable threshold measured signal power
   in paragraphs (a)(1)(i) of this section after an upward adjustment to
   account for the difference in receiver section performance. The upward
   adjustment shall be equal to the increase in the desired signal
   required to restore the receiver section of the subject transceiver to
   the 20 dB C/(I + N) ratio of paragraph (a)(1)(ii)(B) of this section.
   The adjusted threshold levels shall then define the minimum measured
   signal power(s) in lieu of paragraphs (a)(1)(i) of this section at
   which the licensee using such non-compliant transceiver is entitled to
   interference protection.

   (b) Minimum Receiver Requirements. Voice transceivers capable of
   operating in the 806-824 MHz portion of the 800 MHz band, or in the 900
   MHz Business/Industrial Land Transportation Pool, shall have the
   following minimum performance specifications in order for the system in
   which such transceivers are used to claim entitlement to full
   protection against unacceptable interference. (See paragraph (a)(2) of
   this section.)

   (1) Voice units intended for mobile use: 75 dB intermodulation
   rejection ratio; 75 dB adjacent channel rejection ratio; −116 dBm
   reference sensitivity.

   (2) Voice units intended for portable use: 70 dB intermodulation
   rejection ratio; 70 dB adjacent channel rejection ratio; −116 dBm
   reference sensitivity.

   (3) Voice units intended for mobile or portable use in the 900 MHz
   Business/Industrial Land Transportation Pool: 60 dB intermodulation
   rejection ratio; 60 dB adjacent channel rejection ratio; −116 dBm
   reference sensitivity.

   [ 73 FR 67800 , Nov. 17, 2008]

   return arrow Back to Top


Goto Section: 90.671 | 90.673

Goto Year: 2016 | 2018
CiteFind - See documents on FCC website that cite this rule

Want to support this service?
Thanks!

Report errors in this rule. Since these rules are converted to HTML by machine, it's possible errors have been made. Please help us improve these rules by clicking the Report FCC Rule Errors link to report an error.
hallikainen.com
Helping make public information public