Goto Section: 15.519 | 15.523 | Table of Contents

FCC 15.521
Revised as of October 1, 2020
Goto Year:2019 | 2021
  §  15.521   Technical requirements applicable to all UWB devices.

   (a) UWB devices may not be employed for the operation of toys.
   Operation onboard an aircraft, a ship or a satellite is prohibited.

   (b) Manufacturers and users are reminded of the provisions of § § 15.203
   and 15.204.

   (c) Emissions from digital circuitry used to enable the operation of
   the UWB transmitter shall comply with the limits in § 15.209, rather
   than the limits specified in this subpart, provided it can be clearly
   demonstrated that those emissions from the UWB device are due solely to
   emissions from digital circuitry contained within the transmitter and
   that the emissions are not intended to be radiated from the
   transmitter's antenna. Emissions from associated digital devices, as
   defined in § 15.3(k), e.g., emissions from digital circuitry used to
   control additional functions or capabilities other than the UWB
   transmission, are subject to the limits contained in Subpart B of this
   part.

   (d) Within the tables in § § 15.509, 15.511, 15.513, 15.515, 15.517, and
   15.519, the tighter emission limit applies at the band edges. Radiated
   emission levels at and below 960 MHz are based on measurements
   employing a CISPR quasi-peak detector. Radiated emission levels above
   960 MHz are based on RMS average measurements over a 1 MHz resolution
   bandwidth. The RMS average measurement is based on the use of a
   spectrum analyzer with a resolution bandwidth of 1 MHz, an RMS
   detector, and a 1 millisecond or less averaging time. Unless otherwise
   stated, if pulse gating is employed where the transmitter is quiescent
   for intervals that are long compared to the nominal pulse repetition
   interval, measurements shall be made with the pulse train gated on.
   Alternative measurement procedures may be considered by the Commission.

   (e) The frequency at which the highest radiated emission occurs, fM,
   must be contained within the UWB bandwidth.

   (f) Imaging systems may be employed only for the type of information
   exchange described in their specific definitions contained in § 15.503.
   The detection of tags or the transfer or data or voice information is
   not permitted under the standards for imaging systems.

   (g) When a peak measurement is required, it is acceptable to use a
   resolution bandwidth other than the 50 MHz specified in this subpart.
   This resolution bandwidth shall not be lower than 1 MHz or greater than
   50 MHz, and the measurement shall be centered on the frequency at which
   the highest radiated emission occurs, fM. If a resolution bandwidth
   other than 50 MHz is employed, the peak EIRP limit shall be 20 log
   (RBW/50) dBm where RBW is the resolution bandwidth in megahertz that is
   employed. This may be converted to a peak field strength level at 3
   meters using E(dBuV/m) = P(dBm EIRP) + 95.2. If RBW is greater than 3
   MHz, the application for certification filed with the Commission must
   contain a detailed description of the test procedure, calibration of
   the test setup, and the instrumentation employed in the testing.

   (h) The highest frequency employed in § 15.33 to determine the frequency
   range over which radiated measurements are made shall be based on the
   center frequency, fC, unless a higher frequency is generated within the
   UWB device. For measuring emission levels, the spectrum shall be
   investigated from the lowest frequency generated in the UWB
   transmitter, without going below 9 kHz, up to the frequency range shown
   in § 15.33(a) or up to fC + 3/(pulse width in seconds), whichever is
   higher. There is no requirement to measure emissions beyond 40 GHz
   provided fC is less than 10 GHz; beyond 100 GHz if fC is at or above 10
   GHz and below 30 GHz; or beyond 200 GHz if fC is at or above 30 GHz.

   (i) The prohibition in § 2.201(f) and 15.5(d) of this chapter against
   Class B (damped wave) emissions does not apply to UWB devices operating
   under this subpart.

   (j) Responsible parties are reminded of the other standards and
   requirements cross referenced in § 15.505, such as a limit on emissions
   conducted onto the AC power lines.

   [ 67 FR 34856 , May 16, 2002, as amended at  68 FR 19751 , Apr. 22, 2003;
    70 FR 6776 , Feb. 9, 2005]

   


Goto Section: 15.519 | 15.523

Goto Year: 2019 | 2021
CiteFind - See documents on FCC website that cite this rule

Want to support this service?
Thanks!

Report errors in this rule. Since these rules are converted to HTML by machine, it's possible errors have been made. Please help us improve these rules by clicking the Report FCC Rule Errors link to report an error.
hallikainen.com
Helping make public information public