FCC Web Documents citing 15.213
- http://hraunfoss.fcc.gov/edocs_public/attachmatch/FCC-03-149A1.doc http://hraunfoss.fcc.gov/edocs_public/attachmatch/FCC-03-149A1.pdf http://hraunfoss.fcc.gov/edocs_public/attachmatch/FCC-03-149A1.txt
- Washington, D.C.'' Section 15.120 is amended by changing the Federal Communications Commission's mailing address to paragraph (d) to ``Federal Communications Commission, 445 12th Street, S.W., Washington, D.C.'' Section 15.201 is amended by revising paragraph (a) to read as follows: § 15.201 Equipment authorization requirement. (a) Intentional radiators operated as carrier current systems, devices operated under the provisions of §§ 15.211, 15.213, and 15.221, and devices operating below 490 kHz in which all emissions are at least 40 dB below the limits in § 15.209 shall be verified pursuant to the procedures in Subpart J of part 2 of this chapter prior to marketing. * * * * * Section 15.205 is amended by adding new paragraphs (d)(6) and (d)(7). § 15.205
- http://hraunfoss.fcc.gov/edocs_public/attachmatch/FCC-03-223A1.doc http://hraunfoss.fcc.gov/edocs_public/attachmatch/FCC-03-223A1.pdf http://hraunfoss.fcc.gov/edocs_public/attachmatch/FCC-03-223A1.txt
- be considered sufficient to comply with the provisions of this Section. The manufacturer may design the unit so that a broken antenna can be replaced by the user, but the use of a standard antenna jack or electrical connector is prohibited. This requirement does not apply to carrier current devices or to devices operated under the provisions of Sections 15.211, 15.213, 15.217, 15.219, or 15.221. Further, this requirement does not apply to intentional radiators that must be professionally installed, such as perimeter protection systems and some field disturbance sensors, or to other intentional radiators which, in accordance with Section 15.31(d), must be measured at the installation site. However, the installer shall be responsible for ensuring that the proper antenna is employed